Portable Magnetizing Coils

Portable Magnetizing Coils

Parker’s magnetizing coils are designed for magnetic particle inspection and may also be used for demagnetizing.The coils allow for the use of either dry powder or wet Black or fluorescent inspection media.

The coils are moulded in a tough, black polyurethane and comes equipped with a foot or Hand switch and 3mneoprene power cord. The sealed electrical connection box has a 50mm X127mm flat base allowing the coil to stand in a vertical position.

The PL-8Sand PL-10Sare for use on 230vac 50-60 hz single phase grounded power source.

The PL-10PDC(Pulsed DC) operates from 115vac, 50-60 hz single phase grounded power source.

The coils are designed for a 50%duty cycle, or approximately two minutes on and two minutes off.

PL-8S Internal Diameter 203mm. PL-10S Internal Diameter 250mm

MINI Magnetic Yoke B-310S

Magnetic Yokes ‘B310S’is the MINI Model Magnetic Yoke at only 2.7kg with reversible strain-relief –Top or Rear.

The B-310from Parker USA is the Mini size magnetic yoke at only 184mm length but not mini in features- It still maintains full size legs, has a top mounted switch, the 50% duty cycle and exceeds the lift test requirement.All with a two year warranty.

UV Lamp – 3817.001

Magnetic Yokes presents the Parker NDT PB1 Powder Blower.

The PB-1 Hand-held Controlled Magnetic Powder Blower provides reliable and controlled application of magnetic inspection powder to areas previously inaccessible – horizontal, vertical and overhead.

Inline RCD from Magnetic Yokes

Magnetic Yokes Inline RCD from Magnetic Yokes Do You power your Magnetic Yoke from a Generator? Do You power your Magnetic Yoke from a Battery with Inverter? Do You power your Magnetic Yoke from an unprotected Power Supply? Do You use your Magnetic Yoke with a basic Extension Cord? If So!, You need the Inline…

DEUTROMETER 3873

The DEUTROMETER 3873 measures magnetic fields, both Direct & Alternating in the low-frequency range. Specialist knowledge gained by Karl Deutsch acquired over many years enabled the development and assists the continued evolvement of our Deutrometer. The 3873 being current Karl Deutsch model.